|
See
below diagrams to identify which unit and model# is best
suited to accomodate your current aquarium and filtration system.
ECO-Aqualizer is
easily installed alongside other filters and filtration equipment.
Suggested
flow rate: Turn-over entire aquarium water 3 to 9
times per hour. |
 |
A.)
Installed with Hang-On Power Filters, Bio-Wheels or Undergravel Filters.
Circulate tank
water with water pump. Accessories for
installation are included.
Install ECO-AqualizerTM
above your tank water level. Submerge only the pump.
Use ME series
( ME25, ME55 , ME125)
|
|
B.) Installed with canister
filters
Cut the OUTLET hose on the canister
& simply splice in the ECO-Aqualizer.
ECO-AqualizerTM
should be installed in RETURN line back to the
aquarium.
Use X series
(X75, X150, or X225)
|
|
C.) Installed
with Biological Sumps
Can be installed
BEFORE
or AFTER any biological sump. Most optimal when
placed after equipment & before entry back to tank
Only ONE
unit is needed per aquarium.
Use X series
(X75 , X150 , or X225)
|
 |
D.)
Installed
with ECO-System/Refugium
Can be installed
BEFORE
or AFTER the ECO-system sump. Most optimal when
placed after equipment and before entry back into tank.
Only ONE
unit is needed per aquarium.
Use X series
(X75 , X150 , or X225)
|
|
E.)
Installation
for Aquariums of 250 to 400 Gallons
Need to Tee off from one of your lines and run parallel ECO units.
Not consecutive. Units must be at least 4 inches away
from each other. Best if return lines can be dropped
back into 2 different inlet areas.
Install
(2) X-75 for 250 to 325 gallons.
Install (2) X-150 for 325 -
400 gallons.
|
|
|
F.)
Installation for Aquariums 400 to 600 Gallons
Can be installed
BEFORE
or AFTER any biological sump. Most optimal when
placed after equipment & before entry back to tank
Only ONE
unit is needed per aquarium.
Use X series
( X-500 )
|
